Changing Waveform Height - Cardinal Health Alaris 8000 Series Directions For Use Manual

Changing Limit Mode (Continued)
2. To change Limit Mode Setup, press applicable soft key.
OR
To leave Limit Mode Setup unchanged and return to
Main display, press
ETCO2

Changing Waveform Height

1. Press Waveform height soft key.
2. To change Waveform Height, select applicable range
limit.
• mmHg: Displays a waveform for
60
within
0 – 60
range, Waveform Out of Range; Adjust Scaling
message displays until waveform falls back into range
or mmHg option is selected.
0 – 99
• mmHg: Displays a waveform for full
99
range,
0 – 99
3. To return to
ETCO2
5-10
Programming
Channel Options (Continued)
soft key.
EXIT
mmHg range. If t
E CO
mmHg.
Main display, press
t values
E CO
2
value exceeds that
2
t value
E CO
2
soft key.
EXIT
A A
Limit Mode Setup
Adult
Neonatal
>Select an Option or
EXIT
EXIT
A
Channel Options
Limit Mode: Adult
Waveform height: 80 mmHg
Waveform time scale: 5 sec
>Select an Option or
EXIT
EXIT
A A
Waveform Height
60 mmHg
99 mmHg
>Select an Option or
EXIT
EXIT
Alaris System Directions for Use
®
EtCO Module Section
2