Table of Contents
Advertisement
Infusion - NO
The following procedures should be used only when the drug
to be infused is not listed in the Drug Library. When
programming a drug not listed in the Drug Library, the drug
calculation must be programmed using the
key within the Drug Library. There are no limits associated
with any non-library drug calculation.
1.
Perform following steps (reference PC Unit Section of this
, "General Setup and Operation", "Start-Up"):
DFU
a. Power on system.
b. Choose Yes or No to New Patient?
c. Confirm current profile or select a new profile.
d. Enter patient identifier, if required.
2.
Prepare and load syringe/administration set (reference
"Getting Started").
3.
Prime (reference "Getting Started").
4.
Start applicable infusion, as described in following
procedures:
Basic Infusion
Continuous Infusion - Drug Calculation
Bolus Dose
The following procedures should be used only to set up a
Basic Infusion. To program an infusion using Guardrails
Drugs, reference "Primary Infusion - With Guardrails
MX Protection".
The illustrations in this procedure assume the following:
•
Mode (Syringe Module), Drug Calculation, Dynamic
ALL
Pressure Display, Profiles, and Volume Duration
configurable settings are enabled.
•
Syringe Module) and Delay Options configurable
NEOI (
settings are disabled.
1.
Press
CHANNEL SELECT
Alaris
System Directions for Use
®
Pump and Syringe Modules Section
Guardrails
DRUG CALC
Basic Infusion
key.
Suite MX Protection
®
soft
When the pressure sensing disc
Suite
®
is not being used and an occlusion
occurs, there is a risk of infusing
pressurized buildup of infusates
upon correction of the occlusion.
To avoid an inadvertent bolus,
relieve the pressure before
restarting the infusion.
FU
CHANNEL
SELECT
PAUSE
CHANNEL
OFF
RESTART
WARNING
Programming
FU
RATE (mL/h)
CHANNEL
SELECT
PAUSE
CHANNEL
OFF
RESTART
FU
RATE (mL/h)
CHANNEL
SELECT
PAUSE
CHANNEL
OFF
RESTART
2-45
Advertisement
Chapters
Table of Contents
Troubleshooting
