Monitoring Mode - Cardinal Health Alaris 8000 Series Directions For Use Manual

Display references throughout this procedure are for
illustration purposes only.
Reference "General Information", "Features and Displays" and
the PC Unit Section of this
following:
• Displays
• Operating Features, Controls, Indicators
The majority of user interface programming is identical for
both p Modules.
S O
2
1. Perform following steps (reference PC Unit Section of this
, "General Setup and Operation", "Start-Up"):
DFU
a. Power on system.
b. Choose Yes or No to New Patient?
c. Confirm current profile or select a new profile.
d. Enter patient identifier, if required.
2. Attach patient cable and sensor (reference "Getting
Started").
3. Press
CHANNEL SELECT
• may appear in Channel Message display
SEARCHING
until p and pulse readings stabilize (approximately
S O
2
seconds).
15
• If sensor is not attached to a site,
displays.
• To prevent screen from reverting to Main Display,
press key within
ENTER
screen displays.
• If sensor is not attached during message display,
module goes into sleep mode. To begin monitoring
once module is in this mode, press
4. Ensure sensor's red
Alaris System Directions for Use
®
SpO Modules Section
2
for information on the
DFU

Monitoring Mode

key.
SENSOR OFF
seconds after
30
MONITOR
is on.
LED
Main
SPO2
key.
Programming
% SpO 2
PULSE (BPM)
CHANNEL
SELECT
MONITOR
CHANNEL
OFF
4-5
Programming