Changing Pulse Beep Volume - Cardinal Health Alaris 8000 Series Directions For Use Manual

Changing Limit Mode (Continued)
2. To change Limit Mode Setup, press applicable soft key.
OR
To leave Limit Mode Setup unchanged and return to
Main display, press
SPO2

Changing Pulse Beep Volume

1. Press Pulse Beep Volume soft key.
2. To test or change:
a. To test volume level (when not attached to patient),
press Test soft key.
b. To increase volume, press Louder soft key until
desired volume level is attained (
c. To decrease volume, press Softer soft key until
desired volume level is attained.
d. To turn off pulse beep, press Off soft key.
3. To return to
SPO2
NOTE:
The pulse beep must be on to test the volume level. To turn
pulse beep on, press the Louder soft key and adjust as
needed (steps 2b and 2c).
Alaris System Directions for Use
®
SpO Modules Section
2
Channel Options (Continued)
soft key.
EXIT
,
1
Main display, press
or ).
2 3
soft key.
CONFIRM
A A
Limit Mode Setup
Adult
Neonatal
>Select an Option or
EXIT
EXIT
A
Channel Options
Limit Mode: Adult
Pulse Beep Volume: Off
SatSeconds Limits: 10
>Select an Option or
EXIT
EXIT
A A A A
Test Test
Pulse Beep Volume Pulse Beep Volume
Off Off
1 1
Softer Softer Louder Louder
>Press CONFIRM >Press CONFIRM
CONFIRM
Programming
4-11