This Section of the Directions for Use (
p
Module,
and
S
O
8210
2
instructions and information. It is used in conjunction with the
following:
Alaris
PC Point-of-Care Unit ("PC Unit") Section of this DFU
®
Nellcor
and Masimo
®
Maintenance Software and User Manual for Alaris
p
Module sensor and cable Compatibility Cards
S
O
2
p
Module Technical Service Manual
S
O
2
The
p
Modules are indicated for continuous, noninvasive
S
O
2
monitoring of functional oxygen saturation of arterial
hemoglobin (
p
) and pulse rate measured by an
S
O
2
sensor. The
p
Modules and accessories are indicated for
S
O
2
use with adult, pediatric and neonatal patients during both no
motion and motion conditions, and for patients who are well or
poorly perfused in hospitals and hospital-type facilities. Only 1
p
Module can be connected to the Alaris
S
O
2
The
Series
p
8210
S
O
2
cable and a wide variety of O
Series
p
Module uses a wide variety of Masimo
S
O
2
cables and Masimo
sensors. For specific directions for use,
®
reference the applicable cable and sensor packaging.
The majority of user interface programming is identical for
both
p
Modules. If a procedure/information applies to a
S
O
2
specific module, the following identifiers will indicate the model
it applies to.
Series:
8210
(8210)
Series:
8220
(8220)
Cables and Sensors: Reference "General Information" for
"Cables and Sensors" information.
Alaris
System Directions for Use
®
SpO
Modules Section
2
Introduction
) provides Alaris
DFU
Series ("
p
8220
S
O
2
Cable and Sensor Instructions
®
Module uses a Nellcor
M
series sensors. The
®
XI
AX
®
Module"),
System
®
p
S
O
2
System.
®
patient
®
DOC-10
8220
patient
®
Getting Started
WARNING
Read all instructions, for the
Modules and PC Unit, before using
the Alaris
System.
®
CAUTION
O
nly
Getting Started
p
S
O
2
4-1