Primary Infusion - Cardinal Health Alaris 8000 Series Directions For Use Manual

Authorized User Mode
3. Program infusion.
• When no keys have been pressed on PC Unit for a
five-minute period, tamper resist mode is automatically
enabled.
NOTES:
The Authorized User Mode is only enabled if the feature is
enabled in the selected profile and if there is an Auto-ID
Module attached to the PC Unit.
If the system is configured to do so, it is possible to disable
the Authorized User Mode without scanning a clinician's
press and hold the Tamper Resist Switch (on back of PC Unit)
for - seconds.
3 4
In a very low battery condition, with less than
battery time remaining, the scanner is disabled. In this
situation, disable tamper resist by pressing the Tamper Resist
Switch on the back of the PC Unit for
Utilizing the Auto-ID Module to scan
provides the ability to verify the right medication and
concentration, and enhances safety through the use of the
Guardrails Suite MX. It compares the medication identifier
®
from the container bar code with the medication identifier
IV
from the Guardrails
®
container bar code, the system also verifies the right patient.
When the green
READY LED
to scan.
1. To scan bar code on
key on Auto-ID Module or scan trigger on hand-held
scanner.
6-6
Programming
2

Primary Infusion

medication containers
IV
Drug Library. If the patient
illuminates, the system is ready
container, press
IV
(Continued)
;
ID
minutes of
5
seconds.
is in the
ID IV
/
SCAN CANCEL
CAUTIONS
•
CLASS 1 LED PRODUCT
stare into the beam or allow
beam to strike patient's face.
• Always verify that information
displayed on the PC Unit
matches scanned data.
Alaris System Directions for Use
®
Auto-ID Module Section
: Do not