Switch Port Commands; Config Ports - D-Link DGS-3100 SERIES Cli Manual

D-link dgs-3100 series gigabit stackable managed switch
Hide thumbs Also See for DGS-3100 SERIES:
Table of Contents

Advertisement

The Switch Port commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command

config ports

show ports
config ports description
delete ports description
show ports description
Each command is listed in detail, as follows:
config ports
Purpose
Syntax
Description
Parameters
Parameter
[all | <portlist> | <ch1–32>] {speed [auto | 10_half | 10_full | 100_half | 100_full |
1000_full] | flow_control [enable | disable | auto] | learning [enable | disable] |
state [enable | disable]}
{<portlist>}
<portlist> <string 1-64>
<portlist>
{<portlist>}
To configure the Switch's Ethernet port settings.
config ports [all | <portlist> | <ch1–32> ] {speed [auto | 10_half |
10_full | 100_half | 100_full | 1000_full] | flow_control [enable |
disable | auto] | learning [enable | disable] | state [enable |
disable]}
The config ports command configures the Switch's Ethernet port
settings. Only the ports listed in the <portlist> are affected.
<portlist> − A port or range of ports to be configured.
all − Configures all ports on the Switch.
<ch1–32> − A LAG or range of LAGs to be configured.
speed – Sets the speed of a port or range of ports, with the addition
of one of the following:
auto − Enables auto-negotiation for the specified range of
ports.
[10 | 100 | 1000] − Configures the speed in Mbps for the
specified range of ports.
[half | full] − Configures the specified range of ports as either
full or half-duplex.
flow_control [enable] – Enables flow control for the specified ports.
flow_control [disable] – Disables flow control for the specified ports.
flow_control [auto] – Specifies auto-negotiation of flow control for the
specified ports.
learning [enable | disable] − Enables or disables the MAC address
learning on the specified range of ports.
state [enable | disable] − Enables or disables the specified range of
ports.
DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual

SWITCH PORT COMMANDS

5
30

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents