Traceroute - D-Link DGS-3200 SERIES Cli Manual

4-8 traceroute

Purpose
Used to trace the routed path between the switch and a destination endstation.
Format
traceroute <ipaddr> {ttl <value 1-60>} {port <value 30000-64900>} {timeout <sec 1-65535>} {probe
<value 1-9>}
Description
The traceroute command allows you to trace a route between the switch and a give host on the network.
Parameters
Parameters
ipaddr
ttl <value1-60>
port<value
30000-64900>
probe<value 1-9>
Restrictions
You must have administrator privileges.
Example
Trace the routed path between the switch and 10.48.74.121.
D G S - 3 2 0 0 - 1 0 : 4 # t r a c e r o u t e 1 0 . 4 8 . 7 4 . 1 2 1 p r o b e 3
C o m m a n d : t r a c e r o u t e 1 0 . 4 8 . 7 4 . 1 2 1 p r o b e 3
1 < 1 0 m s .
1 < 1 0 m s .
1 < 1 0 m s .
D G S - 3 2 0 0 - 1 0 : 4 #
DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
Description
IP address of the destination endstation.
The time to live value of the trace route request. This is the maximum
number of routers The traceroute command will cross while seeking
the network path between two devices.
The port number. Must be above 1024. The value range is from 30000
to 64900 .
The number of probes. The range is from 1 to 9 .
1 0 . 4 8 . 7 4 . 1 2 1
1 0 . 4 8 . 7 4 . 1 2 1
1 0 . 4 8 . 7 4 . 1 2 1
57