Traceroute Mpls Ipv4 - D-Link DXS-3600 Series Reference Manual

Layer 2/3 managed 10gigabut ethernet switch

Hide thumbs Also See for DXS-3600 Series:

Table of Contents

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide

The fields that can be configured in Ping MPLS are described below:

IPv4 Address

Click the Start button to initiate the ping.

After clicking the Start button, the following page will appear.

Click the Stop button to terminate the ping prematurely.

Click the Back button to return to the previous window.

Traceroute MPLS IPv4

This window is used for hop-by-hop fault localization as well as path tracing the LSP of the specified FEC.

If there is no LSP for the specified FEC, the "Destination unreachable" message will be displayed.

Otherwise, MPLS echo request messages will be sent out to along the LSP of the specified FEC. The

TTL in the outmost label of the MPLS echo requests is set successively to 1, 2, 3, and so on. It forces the

Figure 11-19 Ping MPLS Window

Select and enter the FEC's IPv4 address here whose LSP connectivity

will be checked.

Select and enter the FEC's subnet mask here.

Select and enter the FEC's VC IP address here.

Select and enter the FEC's VC ID here.

Enter the ping time amount here. This is the amount of ping packets

that will be sent out. The range is from 1 and 255. By default, this

Enter the ping timeout value here. The range is from 1 to 99 seconds.

By default, this value is 2 seconds.

Figure 11-20 Ping MPLS (Start) Window