802.1X Supplicant Commands - D-Link 5000 Series Cli Reference Manual

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide

802.1X Supplicant Commands

D-Link OS supports 802.1X (dot1x) supplicant functionality on point-to-point ports. The administrator can
configure the user name and password used in authentication and capabilities of the supplicant port.
5-301 dot1x dynamic-vlan
Use this command to enable the switch to create VLANs dynamically when a RADIUS-assigned VLAN
does not exist in the switch.
No command sets the dot1x dynamic-vlan to default.
dot1x dynamic-vlan {enable}
no dot1x dynamic-vlan
Parameters
enable
Default
The default is None.
Command Mode
Global Config
5-302 dot1x eapolflood
Use this command to enable EAPOL flood support on the switch.
dot1x eapolflood
no dot1x eapolflood
Parameters
None
Default
The default is Auto.
Command Mode
Interface Config
5-303 dot1x supplicant max-start
Enable dot1x dynamic vlan creation configuration.
377