802.1X Management Commands - D-Link DWS-1008 Cli Reference Manual
8 port 10/100 wireless switch with power over ethernet
Hide thumbs
Also See for DWS-1008:
- Cli reference manual (531 pages) ,
- Product manual (502 pages) ,
- User manual (454 pages)
Table of Contents
Advertisement
DWS-1008 CLI Reference Guide
802.1X Management Commands
Use 802. IEEE X management commands to modify the default settings for IEEE 802.1X
sessions on a switch. For best results, change the settings only if you are aware of a
problem with the switch's 802.1X performance.
Caution: 802.1X parameter settings are global for all SSIDs configured on the switch.
clear dot1x bonded-period
Resets the Bonded Auth period to its default value.
Syntax:
Defaults:
Access:
Examples:
DWS-1008# clear dot1x bonded-period
success: change accepted.
clear dot1x max-req
Resets to the default setting the number of Extensible Authentication Protocol (EAP)
requests that the switch retransmits to a supplicant (client).
Syntax:
Defaults:
Access:
Examples:
DWS-1008# clear dot1x max-req
success: change accepted.
D-Link Systems, Inc.
clear dot1x max-req
The default bonded authentication period is 0 seconds.
Enabled.
To reset the Bonded period to its default, type the following command:
clear dot1x max-req
The default number is 20.
Enabled.
To reset the number of 802.1X requests the switch can send to the default
setting, type the following command:
802.1x Management Commands
311
Advertisement
Table of Contents
