802.1X Commands - D-Link DGS-1100-06/ME Cli Reference Manual

The 802.1X commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
enable 802.1x
disable 802.1x
show 802.1x
show 802.1x
auth_state
show 802.1x
auth_configuration
config 802.1x
auth_parameter ports
config 802.1x init
config 802.1x
auth_protocol
config 802.1x reauth
config radius add
config radius delete
config radius
show radius
config 802.1x
auth_mode
create 802.1x guest
vlan
delete 802.1x guest
vlan
config 802.1x
guest_vlan ports
show 802.1x
guest_vlan
create 802.1x user
DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
Parameter
{ports <portlist>}
{ports <portlist>}
[<portlist> | all] [default | { port_control [force_unauth | auto | force_auth] |
quiet_period <sec 0-65535> | tx_period <sec 1-65535> | supp_timeout <sec 1-
65535> | server_timeout <sec 1-65535> | max_req <value 1-10> | reauth_period
<sec 1-65535> | enable_reauth [enable | disable] | direction [both | in]}]
port_based ports [<portlist> | all]
[radius_eap | local]
port_based ports [<portlist> | all]
<server_index 1-3> [<ipaddr> | <ipv6_addr>] [key <passwd 32>] {default |
auth_port <udp_port_number 1-65535> | acct_port <udp_port_number 1-
65535>}
<server_index 1-3>
<server_index 1-3> { key <passwd 32> | auth_port <udp_port_number 1-65535>
| acct_port <udp_port_number 1-65535> | ipaddress [<ipaddr> | <ipv6_addr>] |
retransmit <int 1-255> | timeout <int 1-255>}
[port_based | mac_based]
<vlan_name 32>
<vlan_name 32>
[<portlist> | all] state [enable | disable]
<username 15>

802.1X COMMANDS

173
26