Config Qinq Ports - D-Link xstack DGS-3620 series Reference Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Parameters
None.
Restrictions
None.
Example
To display Q-in-Q:
DGS-3620-28PC:admin#show qinq
Command: show qinq
QinQ Status : Enabled
DGS-3620-28PC:admin#
92-4

config qinq ports

Description
This command is used to configure Q-in-Q port parameters on this Switch.
Format
config qinq ports [<portlist> | all] {role [uni | nni] | missdrop [enable | disable] | outer_tpid
<hex 0x1-0xffff> | use_inner_priority [enable | disable] | add_inner_tag [<hex 0x1-0xffff> |
disable] | [add | delete] vlan_translation_profile <profile_id>}(1)
Parameters
<portlist> - Enter a range of ports to configure.
all - Specifies to configure all ports.
role - Specifies the port role in Q-in-Q mode.
uni - The port is connecting to the customer network.
nni - The port is connecting to the service provider network.
missdrop - Enable or disable the tagged packet drop that does not match any assignment rule in
the VLAN translation and Q-in-Q profile.
enable - Enable miss drop of ports.
disable - Disable miss drop of ports.
outer_tpid - Specifies the outer-TPID of a port.
<hex 0x1-0xffff> - Enter the outer-TPID of a port.
use_inner_priority - Specifies whether to use the priority in the C-VLAN tag as the priority in the
S-VLAN tag. By default, the setting is disabled.
enable - Specifies that the use of the inner priority will be enabled.
disable - Specifies that the use of the inner priority will be disabled.
add_inner_tag - Specifies whether to add inner tag for ingress untagged packets. If set, the inner
tag will be added for the ingress untagged packets and, therefore, the packets that egress to
the NNI port will be double tagged.
<hex 0x1-0xffff> - Enter the inner tag value here.
disable - Specifies that only the s-tag will be added for ingress untagged packets.
1058