Show Qinq; Config Qinq Ports - D-Link DGS-1100-06/ME Cli Reference Manual

Parameters
Restrictions
Example usage:
To disable Q-in-Q:

show qinq

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show the Q-in-Q status for ports 1 to 4:

config qinq ports

Purpose
Syntax
Description
DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
run as static 1Q VLANs. The default setting of Q-in-Q is disabled.
None.
Only administrator-level users can issue this command.
DGS-1100-06/ME:5#disable qinq
Command: disable qinq
Success!
DGS-1100-06/ME:5#
To show global Q-in-Q and port Q-in-Q mode status.
show qinq {ports [<portlist> | all]}
The show qinq command is used to show the global Q-in-Q status,
including: port role in Q-in-Q mode and port outer TPID.
<portlist> - Specifies a range of ports to be displayed.
If no parameter is specified, the system will display all Q-in-Q port
information.
all - Specifies all ports to be displayed.
None.
DGS-1100-06/ME:5# show qinq ports 1-4
Command: show qinq ports 1-4
Port Role Outer TPID
------ ------ ----------------
1 UNI 0x8100
2 UNI 0x8100
3 UNI 0x8100
4 UNI 0x8100
DGS-1100-06/ME:5#
Used to configure Q-in-Q ports.
config qinq ports [<portlist> | all] [role [nni | uni] | outer_tpid
<hex 0x1-0xffff>]
The config qinq ports command is used to configure the port level
setting for the Q-in-Q VLAN function. This setting is not effective
132