Vlan Commands - D-Link DGS-3100 SERIES Cli Manual

DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
The VLAN commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
create vlan
delete vlan
config vlan
config gvrp
enable gvrp
disable gvrp
show vlan
show gvrp
Each command is listed in detail, as follows:
create vlan
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create a VLAN v1, tag 2:
89
Parameter
<vlan_name 32> {tag <vlanid 2-4094>}
<vlan_name 32>
<vlan_name 32> [add [tagged | untagged | forbidden] | delete] [ <portlist> | <ch1-
32> ]
[<portlist> | <ch1-32> | all] { state [enable | disable] { ingress_checking [enable |
disable] | acceptable_frame [tagged_only | admit_all] | pvid <vlanid 1-4094>}
{<vlan_name 32>}
{<portlist> | <ch1-32> ]}
To create a VLAN on the Switch.
create vlan <vlan_name 32> {tag <vlanid 2-4094>}
The create vlan command creates a VLAN on the Switch.
<vlan_name 32> − The name of the VLAN to be created.
tag <vlanid 2-4094> − The VLAN ID of the VLAN to be created. The
allowed values range from 2 to 4094.
Each VLAN name can be up to 32 characters. If the VLAN is not
given a tag, it will be a port-based VLAN.
Only administrator or operator-level users can issue this command.
DGS3100# create vlan v1 tag 2
Success.
DGS3100#

VLAN COMMANDS

14