Cable, Port, And Pinout Information; Pin Connections For The 10/100/1000 Ethernet Interface - D-Link DES-3010PA - Switch Web User Manual

The system LED indications are described in the following table:
Table 6: System LED Indications
Por t D escr ip tio n
PoE Power Overload
FAN
RPS
System
Test

Cable, Port, and Pinout Information

This section describes the device's physical interfaces and provides information about cable connections. Stations
are connected to the device ports through the physical interface ports on the front panel. For each station, the
appropriate mode (Half/Full Duplex, Auto Negotiation) is set. The default is Auto Negotiation.

Pin Connections for the 10/100/1000 Ethernet Interface

The switching port can connect to stations wired in standard RJ-45 Ethernet station mode using straight cables.
Transmission devices connected to each other use crossed cables. The following figure illustrates the pin
allocation.
Figure 8: RJ-45 Pin Allocation
The following table describes the pin allocation
Table 7: RJ-45 Pin Connections for 10/100/1000 Base-T
Pin U se
1 TxRx 1+
2 TxRx 1-
3 TxRx 2+
L ED In dica tio n D escr ip tio n
Flashing Red POE power exceed max power (110w).
Red Fan not functioning.
Red SYSTEM Power fails and RPS Power is operational.
Flashing Red Both SYSTEM Power and RPS Power fail.
Green Device is receiving power.
Off Device is not receiving power.
Flashing Red Device is running POST.
Red Device has POST errors.
Off POST ran without any errors
Cable, Port, and Pinout Information
Page 17
Device Description