Cable Diagnostic Port - D-Link DGS-1100-16/ME Reference Manual

cable diagnostic port

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To determine the copper cables and position of port 11 on the Switch:
DGS-1100-24P/ME:admin#cable diagnostic port 11
Command : cable diagnostic port 11
Port Type
------ ------------------ -------------------- ----------------- --------------------------
11
DGS-1100-24P/ME:admin#
DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
IP Address
Severity
Facility
UDP port
Status : Disabled
DGS-1100-18/ME:admin#
To determine if there are any errors on the copper cables and the
position where the errors may have occurred.
cable diagnostic [port <portlist> | all]
The cable diagnostic port command is used to determine if there
are any errors on the copper cables and the position where the
errors may have occurred. Cable length is detected as following
range: <50m, 50~80, 80~100, >100m. Deviation is +/-5 meters,
therefore "No Cable" may be displayed under "Test Result," when
the cable used is less than 5 m in length. The Fault Distance will
show "No Cable", whether the fiber is connected to the port or not.
Note: The Cable Diagnostics feature is only supported on the
copper ports on all DGS-1100/ME Series switches.
port <portlist> – A port or range of ports to be configured.
all − Specifies all ports on the Switch are to be configured.
Only administrator-level users can issue this command.
Link Status
1000Base_T Link Up
: 10.90.90.100
: All
: Local7
: 514
Test Result Cable Length (M)
Open
59
4