Baseband Block - Clock Settings - R&S AFQ100A Operating Manual

R&S AFQ100A

Baseband Block - Clock Settings

The CLOCk system contains the commands for configuration of the signals at the clock output and
input connectors.
Command
[SOURce:]CLOCk
[SOURce:]CLOCk:INPut:FREQuency?
[SOURce:]CLOCk:INPut:SLOPe
[SOURce:]CLOCk:SOURce
[SOURce:]CLOCk:WBANd[:STATe]
[SOURce:]CLOCk 1 kHz ... 300 MHz
The command sets the output clock rate of the ARB. By default, the clock rate is defined by the
clock tag of the waveform.
Example: CLOC 10MHz
*RST value
-
[SOURce:]CLOCk:INPut:FREQuency?
The command queries the frequency of the external clock signal. An external clock reference must
be supplied at the CLOCK input.
The command is a query command and therefore does not have an *RST value.
Example: CLOC:INP:FREQ?
*RST value
-
[SOURce:]CLOCk:INPut:SLOPe POSitive | NEGative
Clock source external only!
The command sets the active slope of an externally applied clock signal at the CLOCK connector.
Example: CLOC:INP:SLOP NEG
*RST value
POSitive
1401.3084.32
Parameters
1000 Hz ... 300 MHz
-
POSitive | NEGative
INTernal | EXTernal
'sets the output clock rate to 10 MHz.
Resolution Options
0.001 Hz
'queries the measured frequency of the external clock reference.
Resolution Options
-
'the active slope of the external clock signal at the CLOCK connector is the
falling slope.
Resolution Options
-
AFQ Commands - Signal Generation
6.41
Default Remark
unit
Hz
- Query only
-
-
Query only
SCPI
Device-specific
SCPI
Device-specific
SCPI
Device-specific
E-3