R&S AFQ100A Operating Manual page 66

R&S AFQ100A
Establish Manual Remote Control on the Linux/Unix PC
The VNC program is available per default for Linux/Unix operating systems. Only three steps are
necessary to establish the connection to the R&S AFQ:
1. Start the internet browser on the PC.
2. Enter the following address:
vnc://"IP-address of R&S AFQ", e.g. vnc://192.168.1.1
3. Confirm with the
Enter
The password for the remote VNC connection is requested.
4. Enter the password defined in the Default Local System Properties panel of the
program of R&S AFQ.
5. Press the Log On button to confirm.
After the connection is established, the current modulation generator screen with the block diagram is
displayed and the R&S AFQ can be manually remote-controlled from the external PC. The individual
functions are operated using the mouse and keyboard. Specific instrument functions can be executed
using specific key combinations on the keyboard (see table in chapter 3, section
Controls" on page 3.1). In contrast to Remote Control Desktop, direct control on the R&S AFQ is
possible while manual remote-control is established, it can be performed alternately with the
manual remote control.
1401.3078.62
Manual Remote Control via an External Controller
key.
1.46
Ultr@VNC
"Legend of Manual
E-3