R&S AFQ100A Operating Manual page 301

R&S AFQ100A
[SOURce:]TRIGger:OUTPut<[1]...4>:PATTern
The command defines the bit pattern used to generate the marker signal in the setting
SOURce:TRIGger:OUTPut:MODE PATTern 0 is marker off, 1 is marker on.
Example: TRIG:OUTP2:MODE PATT
TRIG:OUTP2:PATT #11D
*RST value
0
[SOURce:]TRIGger:OUTPut<[1]...4>:PULSe:DIVider 2 ... 1024
The command sets the divider for the pulsed marker signal in the setting
SOURce:TRIGger:OUTPut:MODE PULSe. The pulse frequency is derived by dividing the symbol
rate by the divider.
Example: TRIG:OUTP2:PULS:DIV 2
TRIG:OUTP2:FREQ?
Response: "66000"
*RST value
2
[SOURce:]TRIGger:OUTPut<[1]...4>:PULSe:FREQuency?
The command queries the pulse frequency of the pulsed marker signal in the setting
SOURce:TRIGger:OUTPut:MODE PULSe. The pulse frequency is derived by dividing the symbol
rate by the divider. The divider is defined with command :TRIG:OUTP:PULS:DIV.
The command is a query only and therefore has no *RST value.
Example: TRIG:OUTP2:PULS:DIV 4
TRIG:OUTP2:MODE PULS
TRIG:OUTP2:PULS:FREQ?
Response: "33000"
*RST value
-
1401.3084.32
'activates the marker signal according to a bit pattern on output MARKER 2.
'sets a bit pattern for MARKER 2.
Resolution Options
-
'sets the divider for the marker signal on output MARKER 2 to the value 2.
'queries the resulting pulse frequency of the marker signal.
'the resulting pulse frequency is 66 kHz.
Resolution Options
1
'sets the divider for the marker signal on output MARKER 2 to the value 4.
'enables the pulsed marker signal.
'queries the pulse frequency of the marker signal.
'the resulting pulse frequency is 33 kHz.
Resolution Options
-
AFQ Commands - Signal Generation
6.40
SCPI
Device-specific
SCPI
Device-specific
SCPI
Device-specific
E-3