R&S AFQ100A Operating Manual page 117

R&S AFQ100A
Sample Clock
Samples per Period
Phase Offset Q
Res. Frequency
Generate Signal HD
Generate Signal RAM
1401.3084.32
Enters the sample clock frequency for generating a sine test signal.
1 kHz ... 300 MHz
The sample clock rate must not exceed the maximum ARB clock rate
of 300 MHz. Sample clock rates between 300 MHz and 600 MHz are
not available and set to maximum ARB clock rate of 300 MHz.
Remote-control command:
SOUR:TSIG:CLOC 300e6
Enters the number of sample values required from the sine wave per
period.
The resulting clock rate must not exceed the maximum ARB clock rate
of 300 MHz.
The number of sample values is automatically restricted by reference
to the set frequency.
Remote-control command:
SOUR:TSIG:SINE:SAMP 500
Enters the phase offset of the sinewave signal on the Q channel
relative to the sinewave signal on the I channel.
Remote-control command:
SOUR:TSIG:SINE:PHAS 45
Indicates the resulting frequency of the test signal.
Remote-control command:
SOUR:TSIG:SINE:FREQ?
Generates a signal and saves it to a file on HD.
The Create Test Signal window opens automatically and the signal
can be stored as a waveform file.
Remote-control command:
SOUR:TSIG:SINE:CRE:NAM "D:\temp\test.wv"
Generates a signal and uses it as output straight away.
Remote-control command:
SOUR:TSIGn:SINE:CRE
4.6
Baseband Block
E-3