R&S AFQ100A Operating Manual page 205

R&S AFQ100A
Select - Test Point
Voltage - Test Point
State Test Point -
Analog Output Board
1401.3084.32
Calls the dialog for selecting a test point.
The currently selected test point is shown next to the Select button.
Remote-control commands:
DIAG:POIN:CAT?
Response: list of the available test points.
DIAG:MEAS:POIN? 'DIAG_P2V5'
(With remote control, voltage measurement starts as soon as the test
point is selected.)
Displays the measured voltage measurement at the selected test
point.
Remote-control command:
DIAG:MEAS:POIN? 'DIAG_P1V25REF'
Response:
2
Activates the measurement at the test points of the analog output
board.
Remote-control command:n.a.
4.94
General Instrument Settings
E-3