R&S AFQ100A Operating Manual page 271

R&S AFQ100A
[SOURce:]TSIGnal:TSINe[1|2]:FREQuency?
The command queries the resulting frequency of the two sine waves. The values of both
components of the test signal are queried separately.
The command is a query command and therefore has no *RST value.
Example: TSIG:TSIN1:FREQ?
TSIG:TSIN2:FREQ?
Response:
*RST value
-
[SOURce:]TSIGnal:TSINe:TLENgth 20 ... 256000
This command enters the number of sample values of a waveform.
1 kHz ... 300 MHz
The sample clock rate must not exceed the maximum ARB clock rate of 300 MHz. Sample clock
rates between 300 MHz and 600 MHz are not available and set to maximum ARB clock rate of 300
MHz.
The number of sample values is automatically restricted by reference to the set frequency.
Example: SOUR:TSIG:TSIN:TLEN 10000
*RST value
100
[SOURce:]TSIGnal:TSINe:OFFSet -1 ... +1 FS
The command sets a DC component.to the test signal.
Example: TSIG:TSIN:OFFS 0.1
*RST value
0
1401.3084.32
'queries the resulting frequencies of the sine waves 1 and 2.
"12 MHz" for sine wave 1 and
"18 MHz" sine wave 2.
Resolution Options
'the waveform is stored by 10000 values.
Resolution Options
-
'sets an offset of 0.1 FS.
Resolution Options
AFQ Commands - Signal Generation
6.10
SCPI
Device-specific
SCPI
Device-specific
SCPI
Device-specific
E-3