R&S AFQ100A Operating Manual page 296

R&S AFQ100A
[SOURce:]WSEGment:NEXT
This command determines which segment the instrument shall generate after a following trigger
event.
Example: SOUR:WAV:SEL "D:\TEMP\SineTriRectMarker.wv"
SOUR:WSEG:NEXT 2
*RST value
-
[SOURce:]WSEGment:NEXT:MODE AINCrement | FPARallel | FSERial
The command sets the segment sequence mode of a multi segment waveform.
AINCrement (Auto Increment)
Parameter:
FPARallel (FHOP Parallel)
Note:
FSERial (FHOP Serial)
Example: WSEG:NEXT:MODE FPAR
*RST value
AINC
1401.3084.32
'selects a waveform file.
'selects the second segment of the current waveform.
Resolution Options
-
The indices of the segments are incremented automatically.
The indices of the segments are fed in parallel as binary digits via the BERT
BNC connectors.
The FHOP mode requires the hardware revisions: Baseboard 3 Rev. 5 and
SFB > Rev. 01.05.05.
The indices of the segments are fed in via the serial FHOP bus of the BERT
BNC connectors.
'selects the segment sequence mode FHOP Parallel.
Resolution Options
-
AFQ Commands - Signal Generation
6.35
SCPI
Device-specific
SCPI
Device-specific
E-3