R&S AFQ100A Operating Manual page 127

R&S AFQ100A
Execute - Trigger
Delay - Trigger
1401.3084.32
using either the command *GET, *TRG or
TRIG:EXEC.
Remote-control command:
SOUR:TRIG:SOUR BUS
(Sync mode Master and Normal only)
Auto
The trigger event is executed internally by the
firmware. Signal output starts immediately when
a signal is loaded and State is on. Trigger events
are ignored.
Remote-control command:
SOUR:TRIG:SOUR AUTO
(Trigger source manual only)
Executes the trigger manually. A manual trigger can be executed only
when a manual trigger source has been selected.
Remote-control commands:
SOUR:TRIG:SOUR MAN
SOUR:TRIG:EXEC
Sets the trigger signal delay on external triggering. This enables the
instrument to be synchronized with the device under test or other
external devices. A delay can onlöy be entered with an external trigger
source.
Remote-control command:
SOUR:TRIG:EXT:DEL 5
4.16
Baseband Block
E-3