R&S AFQ100A Operating Manual page 67

R&S AFQ100A
Install VNC Viewer and Establish VNC Connection on the Windows PC
The Ultr@VNC program is available on the Internet as a free-of-charge download.
Following the instructions on the Internet, the program can be copied onto the external Windows PC.
Only the program component VNC Viewer is required.
Note:
The VNC Viewer program is included in the download for the installation of the Ultr@VNC program
on your modulation generator if Full installation was selected in the Select Component panel. In
this case, the program ultr@vncviewer.exe can be copied to your Windows PC.
1. Install VNC Viewer program component on the PC.
2. Start VNC Viewer program component on the PC.
3. Enter IP address of R&S AFQ in input line VNC Server.
4. Initialize the connection by pressing the Connect button.
A message requesting the password is displayed.
5. Enter the VNC password defined in the Default Local System Properties panel of the
program of R&S AFQ.
6. Press the Log On button to confirm.
After the connection is established, the current modulation generator screen with the block diagram is
displayed and the R&S AFQ can be manually remote-controlled from the external PC. The individual
functions are operated using the mouse and keyboard. Specific instrument functions can be executed
using specific key combinations on the keyboard (see table in chapter 3, section
Controls" on page 3.1). In contrast to Remote Control Desktop, direct control on the R&S AFQ is
possible while manual remote-control is established, it can be performed alternately with the
manual remote control.
1401.3078.62
Manual Remote Control via an External Controller
1.47
Ultr@VNC
"Legend of Manual
E-3