R&S AFQ100A Operating Manual page 347

R&S AFQ100A
STATus:OPERation:ENABle
The command sets the bits of the ENABle part of the STATus:OPERation register. This setting
determines which events of the Status-Event part are forwarded to the sum bit in the status byte.
These events can be used for a service request.
This command triggers an event and therefore has no *RST value and no query form.
Example: STAT:OPER:ENAB 32767
*RST value
-
STATus:OPERation:NTRansition
The command sets the bits of the NTRansition part of the STATus:OPERation register. If a bit is set,
a transition from 1 to 0 in the condition part causes an entry to be made in the EVENt part of the
register. The disappearance of an event in the hardware is thus registered, e.g. the end of an
adjustment.
This command triggers an event and therefore has no *RST value and no query form.
Example: STAT:OPER:NTR 0
*RST value
-
STATus:OPERation:PTRansition
The command sets the bits of the PTRansition part of the STATus:OPERation register. If a bit is set,
a transition from 0 to 1 in the condition part causes an entry to be made in the EVENt part of the
register. A new event in the hardware is thus registered, e.g. the start of an adjustment.
This command triggers an event and therefore has no *RST value and no query form.
Example: STAT:OPER:PTR 32767
*RST value
-
1401.3084.32
'all events are forwarded to the sum bit of the status byte.
Resolution Options
-
'a transition from 1 to 0 in the condition part of the Status:Operation register
does not cause an entry to be made in the EVENt part.
Resolution Options
-
'all transitions from 0 to 1 in the condition part of the Status:Operation register
cause an entry to be made in the EVENt part.
Resolution Options
-
AFQ Commands - Setup Section
SCPI
Compliant
SCPI
Compliant
SCPI
Compliant
6.86 E-3