R&S AFQ100A Operating Manual page 335

R&S AFQ100A
DIAGnostic:AOUTput:POINt:CATalog?
The command measures the voltage the test points available in the instrument.
The command is a query command and therefore has no *RST value.
Example: DIAG:AOUT:POIN:CAT?
Response: 'GND,VREF_2,DIAG_3V3,DIAG_5V,DIAG_12V,...'
*RST value
-
DIAGnostic:AOUTput<CH>:POINt?
The command triggers voltage measurement at the specified test point of the analog output module
and returns the measured voltage. A detailed description of the test points can be found in chapter
3, section "Trouble Shooting" of the service manual.
A list of the available test points can be queried using the DIAG:AOUT:POIN:CAT? command.
The command is a query command and therefore has no *RST value.
Example: DIAG:AOUT:POIN? "GND"
Response: 0.000000
*RST value
-
DIAGnostic:BGINfo? <module name>
The command checks the modules available in the instrument using the variant and revision state.
If the command is sent without parameters being specified, a complete list of all modules is returned
(the various entries are separated by commas). The length of the list is variable and depends on the
instrument equipment configuration.
If the command is sent with parameters, a list of the specified modules is returned (the various
entries are separated by commas). A list of modules names can be called up using the
DIAG:BGIN:CATalog? command .
Each entry for one module consists of four parts which are separated by space characters:
Module name Module stock number incl. variant Module revision Module serial number.
The path for which the query is performed is determined by the numerical suffix.
1401.3084.32
'queries the analog output test points available in the instrument.
Resolution Options
-
'queries the voltage (V) of the test point GND.
Resolution Options
-
AFQ Commands - Setup Section
6.74
SCPI
Device-specific
SCPI
Device-specific
E-3