Diagnostic - Setup Test - R&S AFQ100A Operating Manual

R&S AFQ100A

Diagnostic - Setup Test

The Diagnostic dialog can be selected in the Test section of the Setup menu.
The Diagnostic dialog provides access to the internal diagnosis facilities of the instrument.
The Test Point section provides access to the test points available in the instrument except for the
analog output board (see below). When activated, the voltage of the selected test point is measured
and displayed. A detailed description of the test points can be found in chapter 3 of the service manual.
The Analog Output Board Test Point section provides access to the test points on the analog output
board.
In the Fan Control section the fan speed is selected.
State - Test Point
1401.3084.32
Activates the measurement of the voltage at the selected test point.
Remote-control command:
DIAG:MEAS:POIN? 'DIAG_IQOP3_LCM_CAL_I'
Response:
2
4.93
General Instrument Settings
E-3