R&S AFQ100A
Syntax error (-102)
The command is invalid.
The command contains block data the instrument does not accept.
Example:
Command error - sets bit 5 in the ESR register.
SCPI:
System error (-310)
This error message suggests an error within the instrument. Please inform the R&S Service.
Device specific error - sets bit 3 in the ESR register.
SCPI:
Too many digits (-124)
The decimal numeric data element contains too many digits.
SCPI:
Too much data (-223)
More data were sent by the host than the signal generator can handle.
Execution error - sets bit 4 in the ESR register.
SCPI:
Undefined header (-113)
The sent command header has not been defined.
Header :*XYZ is undefined for every instrument.
Example:
Command error - sets bit 5 in the ESR register.
SCPI:
1401.3084.32
Command error - sets bit 5 in the ESR register.
Alphabetical List of SCPI-Error Messages
9.9
E-3