Arb - Table Sine Test Signal Dialog - R&S AFQ100A Operating Manual

R&S AFQ100A
Offset - Rect Test
Signal
Generate Signal HD -
Rect Test Signal
Generate Signal RAM -
Rect Test Signal

ARB - Table Sine Test Signal Dialog

The Table Sine Test Signals dialog is accessed via the ARB main dialog. The dialog can be used to
configure a table sine test signal, i.e. a superposition of two sine waves. Both paths (I and Q) get the
same signal.
1401.3084.32
Enters a DC component.
Remote-control command:
SOUR:TSIG:RECT:OFFS 0.1
Generates a signal and saves it to a file on HD.
The Create Test Signal window opens automatically and the signal
can be stored as a waveform file.
Remote-control command:
SOUR:TSIG:RECT:CRE:NAM "D:\temp\test.wv"
Generates a signal and uses it as output straight away.
Remote-control command:
SOUR:TSIG:RECT:CRE
In the upper section of the dialog, the table length and
the offset of the resulting signal can be selected. The
table length is the number of sample values of the whole
waveform.
In the Sine 1 section the first sine signal is configured.
In the Sine 2 section the second sine signal is
configured.
In the lower section of the dialog, buttons to load or save
the test signal are provided
4.8
Baseband Block
E-3