R&S AFQ100A Operating Manual page 343

R&S AFQ100A
MMEMory:DCATalog:LENGth? <path>
This command reads out the number of subdirectories in the specified directory. If no directory is
specified, the directory selected with the MMEM:CDIR command is read out.
The command is a query command and therefore has no *RST value.
Example: MMEM:DCAT:LENG
Response: '3'
*RST value
-
MMEMory:DELete <file_name>
This command deletes the specified file.
The command triggers an event and therefore has no query form and no *RST value.
Example: MMEM:DEL 'D:\USER\TEST1.SAVRCL'
*RST value
-
MMEMory:LOAD:STATe 4,<file_name>
This command loads the specified file stored under the specified name in an internal memory.
The Instrument must be activated using an *RCL command with the number used after the file has
been loaded (see section
"*SAV 4"
Example:
MMEM:STOR:STAT 4,'D:\user\test4.savrcl'
MMEM:LOAD:STAT 4,'D:\user\test4.savrcl'
*RCL 4
*RST value
-
1401.3084.32
'reads out the number of subdirectories in the current directory.
'there are 3 subdirectories in the current directory.
Resolution Options
-
'deletes the file 'Test1.savrcl' in the USER directory on the internal hard
disk.
Resolution Options
-
Introduction - Common
'stores the current instrument setting in an intermediate memory with number
4.
'stores the instrument setting stored with the *SAV command under memory
number 4 in the file 'Test4.savrcl' in the USER directory of the internal
hard disk.
'loads the file 'Test4.savrcl' in the USER directory of the internal hard
disk.
'activates the instrument setting of the file 'Test4.savrcl'.
Resolution Options
-
AFQ Commands - Setup Section
SCPI
Device-specific
SCPI
Compliant
Commands, page 6.1).
SCPI
Compliant
6.82 E-3