R&S AFQ100A Operating Manual page 132

R&S AFQ100A
1401.3084.32
Run Mode "Single"
Each segment trigger event switches to the next
segment. A regular trigger event resets signal
generation.
Run Mode "Repeat N Times"
Each segment trigger event switches to the next
segment. A regular trigger event resets signal
generation. Generation of the multi segment
waveform is repeated as often as Repeat Count
of the regular trigger mode is set.
Remote-control command:
SOUR:TRIG:SEGM:MODE SING
Multiple output of the waveform segments. Each
Repeat N Times
segment is repeated as often as the segment
Repeat Count of the particular segment is set
(see
Run Mode "Continuous"
The next segment starts to be output after a
segment trigger event. After finishing the
waveform the instrument switches to the idle
mode. Either a segment or a regular trigger event
restart signal generation.
Run Mode "Single"
The next segment starts to be output after a
segment trigger event. After finishing the
waveform the instrument switches to the idle
mode. The waveform output can be restarted by
switching off and then switching on the ARB state
in the Baseband Block.
4.21
Repeat Count, on page 4.22).
Baseband Block
E-3