Baseband Block - Marker Settings - R&S AFQ100A Operating Manual

R&S AFQ100A

Baseband Block - Marker Settings

Command
[SOURce:]TRIGger:OUTPut:DELay:FIXed
[SOURce:]TRIGger:OUTPut<[1]...4>:DELay
[SOURce:]TRIGger:OUTPut<[1]...4>:DELay:MAXimum?
[SOURce:]TRIGger:OUTPut<[1]...4>:DELay:MINimum?
[:SOURce]:TRIGger:OUTPut<[1]...4>:LIST
[SOURce:]TRIGger:OUTPut<[1]...4>:MODE
[SOURce:]TRIGger:OUTPut<[1]...4>:OFFTime
[SOURce:]TRIGger:OUTPut<[1]...4>:ONTime
[SOURce:]TRIGger:OUTPut<[1]...4>:PATTern
[SOURce:]TRIGger:OUTPut<[1]...4>:PULSe:DIVider
[SOURce:]TRIGger:OUTPut<[1]...4>:PULSe:FREQ?
[SOURce:]TRIGger:OUTPut:DELay:FIXed ON | OFF
The command restricts the marker delay setting range to the dynamic range. In this range the delay
can be set without restarting the marker and signal. If a delay is entered in setting ON but is outside
this range, the maximum possible delay is set and an error message is output.
The numeric suffix in OUTPut has no significance for this command, since the setting always affects
every marker.
Example: TRIG:OUTP:DEL:FIX ON
*RST value
OFF
[SOURce:]TRIGger:OUTPut<[1]...4>:DELay 0 ... 2^20-1 Samples
The command defines the delay between the signal on the marker outputs and the start of the
signals, expressed in terms of samples. Command :TRIGger:OUTPut:DELay:FIXed ON can be
used to restrict the range of values to the dynamic range, i.e. the range within which a delay of the
marker signals can be set without restarting the marker and signal.
Example: TRIG:OUTP2:DEL 16
*RST value
0
1401.3084.32
'restricts the marker signal delay setting range to the dynamic range.
Resolution Options
-
'sets a delay of 16 samples for the signal on connector MARKER 2.
Resolution Options
1 S
AFQ Commands - Signal Generation
Parameter
ON | OFF
0 ... 2^20-1 Samples
-
-
-
UNCHanged | RESTart | PULSe |
PATTern | RATio | LIST
1 ... max_wavelength -1 samples
1 ... max_wavelength -1 samples
2...2^10
6.36
Default Note
unit
S
Query only
Query only
S
S
Query only
SCPI
Device-specific
SCPI
Device-specific
E-3