Status Subsystem - R&S AFQ100A Operating Manual

R&S AFQ100A

Status Subsystem

This system contains the commands for the status reporting system. *RST has no effect on the status
registers.
Queries return the current value of the respective register, which permits a check of the device status. A
decimal value between 0 and 32767 (=2
The configuration commands set the respective register thus determining which status changes of the
instrument causes the status registers to be changed. A decimal value between 0 and 32767 (= 2^15-1)
is set.
Command
STATus:OPERation:CONDition?
STATus:OPERation:ENABle
STATus:OPERation:NTRansition
STATus:OPERation:PTRansition
STATus:OPERation[:EVENt]?
STATus:PRESet
STATus:QUEStionable:CONDition?
STATus:QUEStionable:ENABle
STATus:QUEStionable:NTRansition
STATus:QUEStionable:PTRansition
STATus:QUEStionable[:EVENt]?
STATus:QUEue[:NEXT]?
STATus:OPERation:CONDition?
The command queries the content of the CONDition part of the STATus:OPERation register. This
part contains information on the action currently being performed in the instrument. The content is
not deleted after being read out since it indicates the current hardware status.
The command is a query command and therefore has no *RST value.
Example: STAT:OPER:COND?
*RST value
-
1401.3084.32
15
-1) is returned.
'queries the Status:Operation:Condition register.
Resolution Options
-
AFQ Commands - Setup Section
Parameters
0...32767
0...32767
0...32767
0...32767
0...32767
0...32767
SCPI
Compliant
6.85
Default Remark
unit
Query only
No query
No query
No query
Query only
No query
Query only
No query
No query
No query
Query only
Query only
E-3