Output Block; Introduction - R&S AFQ100A Operating Manual

R&S AFQ100A

Output Block

Introduction

The dialog for adjusting the output ports can be accessed in the Output function block by selecting
config... or by selecting Output in the Edit menu.
In the upper part of the dialog, the output (analog or digital) is selected and activated. The dialog differs
depending on the selected output.
State
Active Output
In the following, first the settings for the analog output and then the settings for the digital output are
described.
1401.3084.32
Switches On or Off the active output. The selected output, either
analog or digital is activated or deactivated, respectively.
Remote-control command:
SOUR:OUTP:STAT ON
Selects the output mode. Two output modes cannot be actived at the
same time. The selection offered depends on the fitted output boards.
If there is only one board fitted, e.g. an analog one, the menu item
Analog Out is selectable solely. Only instrument version R&S AFQ-
B18 is equipped with a digital output board. Then, the user decides
whether the analog or the digital board shall be switched on. If a
second digital output board is installed, the user has to select either
DIGITAL1 or DIGITAL2. In the same way the user has to select
either ANALOG1 or ANALOG2 if the instrument is equipped with two
analog output boards.
One digital and one analog output are fitted. The
Digital /
digital or analog output can be activated.
Analog
Remote-control command:
SOUR:OUTP:AOUT DIG | ANAL
Two analog outputs are fitted. One of them can be
Analog1 /
activated.
Analog2
Remote-control command:
SOUR:OUTP:AOUT ANALOG1 | ANALOG2
Two digital outputs are fitted. One of them can be
Digital1
activated.
/Digital2
Remote-control command:
SOUR:OUTP:AOUT DIGITAL1 | DIGITAL2
4.57
Output Block
E-3