R&S AFQ100A Operating Manual page 349

R&S AFQ100A
STATus:QUEStionable:ENABle
The command sets the bits of the ENABle part of the STATus:QUEStionable register. This setting
determines which events of the Status-Event part are enabled for the sum bit in the status byte.
These events can be used for a service request.
This command triggers an event and therefore has no *RST value and no query form.
Example: STAT:OPER:ENAB 1
*RST value
-
STATus:QUEStionable:NTRansition
The command sets the bits of the NTRansition part of the STATus:QUEStionable register. If a bit is
set, a transition from 1 to 0 in the condition part causes an entry to be made in the EVENt part of the
register.
This command triggers an event and therefore has no *RST value and no query form.
Example: STAT:OPER:NTR 0
*RST value
-
STATus:QUEStionable:PTRansition
The command sets the bits of the PTRansition part of the STATus:QUEStionable register. If a bit is
set, a transition from 0 to 1 in the condition part causes an entry to be made in the EVENt part of the
register.
This command triggers an event and therefore has no *RST value and no query form.
Example: STAT:OPER:PTR 32767
*RST value
-
1401.3084.32
'problems when performing an adjustment cause an entry to be made in the
sum bit.
Resolution Options
-
'a transition from 1 to 0 in the condition part of the Status:Questionable
register does not cause an entry to be made in the EVENt part.
Resolution Options
-
'all transitions from 0 to 1 in the condition part of the Status:Questionable
register cause an entry to be made in the EVENt part.
Resolution Options
-
AFQ Commands - Setup Section
SCPI
Compliant
SCPI
Compliant
SCPI
Compliant
6.88 E-3