Connecting A Mouse; Connecting An External Monitor - R&S AFQ100A Operating Manual

R&S AFQ100A

Connecting a Mouse

A commercial mouse with a USB interface can be connected to the R&S AFQ. A mouse simplifies
control of the block diagram and of associated menus in manual control. It is sufficient for operation of
Windows XP when used together with the on-screen keyboard.
The mouse is connected to one of the USB interfaces, type A, either at the front panel of the instrument
or at the rear panel. The mouse can be connected while the instrument is running, rebooting is not
required.
USB connector at the front panel
The mouse is detected automatically when it is connected. Special settings such as mouse cursor
speed etc, can be made in the Start - Control Panel - Mouse menu of Windows XP. The menu can be
accessed by pressing the Windows key on the external keyboard.

Connecting an External Monitor

NOTICE Overvoltage hazard!
Connecting a monitor while the instrument is switched on the monitor and instrument
may be impaired. A monitor must not be connected until the instrument is switched off
(standby).
Prior to connect a monitor switch off the instrument.
Do not modify the screen driver (Display type) and the display configuration since
this will impair instrument operation.
An external monitor with an analog interface can be connected to the MONITOR connector on the rear
panel of the R&S AFQ. An external monitor is a prerequisite for manual control of the instrument and for
operation of Windows XP without a remote desktop connection to an external PC.
Connection
Before the external monitor is connected, the instrument must be switched off (standby mode) to
prevent damage to the monitor and the R&S AFQ. After connection, the external monitor is detected
when the instrument is started. The generator screen with all elements, e.g. block diagram, Winbar, etc,
is then displayed on the external monitor and on the R&S AFQ. Further settings are not required.
1401.3078.62
USB connectors at the rear panel
1.24
Connecting a Mouse
E-3