R&S AFQ100A Operating Manual page 273

R&S AFQ100A
[SOURce:]TSIGnal:RECT:CREate:NAMed <waveform filename>
The command generates a rectangular test signal and stores the file on the local hard disk (HD).
The Create Test Signal window opens automatically and the signal can be stored as a waveform
file.
This command triggers an event and therefore has no *RST value and no query form.
Example: TSIG:RECT:CRE:NAM "D:\temp\test.wv"
*RST value
-
[SOURce:]TSIGnal:RECT:OFFSet -1 ... +1 FS
The command sets a DC component.to the rectangular test signal.
Example: TSIG:RECT:OFFS 0.1
*RST value
0
[SOURce:]TSIGnal:SINE:SAMPles 4 ... 1000 samples
The command sets the number of sample values required from the rectangular wave per period.
The resulting clock rate must not exceed the maximum ARB clock rate of 300 MHz.
Example: TSIG:RECT:SAMP 500
*RST value
100
[SOURce:]TSIGnal:SINE:CREate
The command generates a waveform which is output straight away.
This command triggers an event and therefore has no *RST value and no query form.
Example: TSIG:SINE:CRE
*RST value
-
1401.3084.32
'writes the generated waveform file to 'test.wv' on the HD.
Resolution Options
'sets an offset of 0.1 FS.
Resolution Options
'sets the number of samples to 500 for a period.
Resolution Options
'a signal is generated and output directly.
Resolution Options
AFQ Commands - Signal Generation
6.12
SCPI
Device-specific
SCPI
Device-specific
SCPI
Device-specific
SCPI
Device-specific
E-3