R&S AFQ100A Operating Manual page 139

R&S AFQ100A
1401.3084.32
A regular marker signal (strobe) is generated. The
Pulse
pulse frequency is defined by entering a divider. The
frequency is derived by dividing the sample rate by
the divider. When Pulse is selected an input box for
the divider and the resulting pulse frequency are
displayed (see also
Remote-control command:
SOUR:TRIG:OUTP1:MODE PULS
SOUR:TRIG:OUTP1:PULS:DIV 4
SOUR:TRIG:OUTP1:PULS:FREQ?
A marker signal that is defined by a bit pattern is
Pattern
generated. The pattern has a maximum length of 32
bits and is defined in an input field. When Pattern is
selected, an additional button indicating a binary
number appears on the right.
Clicking on this button, the input field for entering the
the pattern opens (see also
Remote-control command:
SOUR:TRIG:OUTP1:MODE PATT
SOUR:TRIG:OUTP1:PATT #11F
A regular marker signal that is defined by an on/off
Ratio
ratio is generated. A period lasts one on and off
cycle.
Start of signal
ON time
When Ratio is selected the input boxes for entering
the ON/OFF time are displayed (see also
Off Time
time are each expressed as a number of samples.
Remote-control command:
SOUR:TRIG:OUTP1:MODE RAT
SOUR:TRIG:OUTP1:OFFT 30
SOUR:TRIG:OUTP1:ONT 20
4.28
Divider - Marker, on page 4.29).
Pattern
ON time
OFF time
, on page 4.30). The ON time and OFF
Baseband Block
, on page 4.29).
OFF time
OnTime /
E-3