R&S AFQ100A Operating Manual page 233

R&S AFQ100A
4. Enter the IP address of the R&S AFQ and select VXI-11 Instrument
(the computer name may be entered instead).
5. Press the Test button
A message indicates whether the link to the R&S AFQ can be set up or not. If a connection cannot
be set up, check whether the controller and the instrument are connected to the network (network
cable) and switched on. Correct spelling of the IP address or the computer name can also be
checked. For further error location, inform the network administrator. In large networks,
specification of additional addresses may be required for link setup, e.g. gateway and subnet mask,
which are known to the network administrator.
6. Press the Next button.
An alias name for the instrument can be entered in the next window. This name must not be
mistaken for the computer name. It is only used for instrument identification within the program and
displayed in the menu as an option in case of an Ethernet link.
1401.3084.32
Switchover to Remote Control
5.10 E-3