R&S AFQ100A Operating Manual page 354

R&S AFQ100A
SYSTem:ERRor:COUNt?
The command queries the number of entries in the error queue. If the error queue is empty, '0' is
returned.
The command is a query command and therefore has no *RST value.
Example: SYST:ERR:CODE?
Response: "1"
*RST value
-
SYSTem:ERRor[:NEXT]?
The command queries the oldest entry in the error queue and then deletes it. Positive error numbers
denote device-specific errors, and negative error numbers denote error messages defined by SCPI
(see chapter 9 Error
command is identical to the command STATus:QUEue:NEXT?.
The command is a query command and therefore has no *RST value.
Example: SYST:ERR?
Response: "0", no error
*RST value
-
SYSTem:FPReset
The command triggers an instrument reset to the original state of delivery. This includes also the
parameters, that are unchanged when executing a regular Preset with the
IEC/IEEE bus address.
However, password settings and all settings protected by these password are not changed, e.g.
disabled USB connections, LAN settings and reference oscillator setting.
The command triggers an event and therefore has no *RST value and no query form.
Example: SYST:FPR
*RST value
-
1401.3084.32
'queries the oldest entry in the error queue.
'one error has occurred since the error queue was last read out.
Resolution Options
-
Messages). If the error queue is empty, 0 ("No error") is returned. The
'queries the oldest entry in the error queue.
'no errors have occurred since the error queue was last read out.
Resolution Options
-
'all instrument settings (also those that are not currently active) are reset to the
factory values.
Resolution Options
-
AFQ Commands - Setup Section
SCPI
Compliant
SCPI
Compliant
SCPI
Device-specific
6.93
command, e.g.
*RST
E-3