R&S AFQ100A Operating Manual page 270

R&S AFQ100A
[SOURce:]TSIGnal:PATTern:Q 0 ... 65535
Enters the pattern number of the Q component.
Example: TSIG:TSIN:PATT:Q 2
*RST value
0
[SOURce:]TSIGnal:TSINe[1|2]:AMPLitude 0 ... +0.5 FS
The command sets the amplitude values of the sine waves. The values are set separately for each
sine wave of the test signal. The abbreviation FS means full scale.
Example: TSIG:TSIN1:AMPL 0.3
TSIG:TSIN2:AMPL 0.4
*RST value
0.8
[SOURce:]TSIGnal:TSINe:CREate
The command generates a waveform which is output directly.
This command triggers an event and therefore has no *RST value and no query form.
Example: TSIG:TSIN:CRE
*RST value
-
[SOURce:]TSIGnal:TSINe:CREate:NAMed <waveform filename>
The command generates a sine test signal and stores the file on the local hard disk (HD).
The Create Test Signal window opens automatically and the signal can be stored as a waveform
file.
This command triggers an event and therefore has no *RST value and no query form.
Example: TSIG:TSIN:CRE:NAM "D:\temp\test.wv"
*RST value
-
1401.3084.32
'sets the test pattern for the Q component to 2.
Resolution Options
'sets the amplitude of sine wave 1 to 0.3 FS and
the amplitude of the second sinewave to 0.4 FS.
Resolution Options
'a signal is generated and output directly.
Resolution Options
'writes the generated waveform file to 'test.wv' on the HD.
Resolution Options
AFQ Commands - Signal Generation
6.9
SCPI
Device-specific
SCPI
Device-specific
SCPI
Device-specific
SCPI
Device-specific
E-3