R&S AFQ100A Operating Manual page 365

R&S AFQ100A
In the 'Measurement & Automation Control' program, this setting is made on the Template tab.
VXI-11 Interface Messages
On the Ethernet link, the interface messages are called low-level control messages. These messages
can be used to emulate interface messages of the IEC/IEEE bus.
Command
&ABO (Abort)
&DCL (Device Clear)
&GTL (Go to Local)
&GTR (Go to Remote)
&GET (Group Execute Trigger)
&LLO (Local Lockout)
&POL (Serial Poll)
&NREN (Not Remote Enable)
Table 8-4 VXI-11 Interface Messages
1401.3084.32
Effect on the instrument
Aborts the processing of the commands just received.
Aborts the processing of the commands just received and sets the command
processing software to a defined initial state. Does not change the instrument
setting.
Transition to the "Local" state (manual control)
Transition to the "Remote" state (remote control)
Triggers a previously active device function (e.g. a sweep). The effect of the
command is the same as with that of a pulse at the external trigger signal
input.
Disables switchover from remote control to manual control by means of the
front panel keys
Starts a serial poll
Enables switchover from remote control to manual control by means of the
front panel keys
8.8
Hardware Interfaces
E-3