R&S AFQ100A Operating Manual page 272

R&S AFQ100A
[SOURce:]TSIGnal:TSINe[1|2]:PERiods 1 ... 50
The command sets the number of periods for the sine waves. The values are set separately for
each component of the test signal.
Example: TSIG:TSIN1:PER 4
TSIG:TSIN2:PER 6
*RST value
4
[SOURce:]TSIGnal:TSINe[1|2]:PHASe -360 ... 360 degree
Sets the phase shifts of the sine waves. The values are set separately for each sine wave of the test
signal.
Example: TSIG1:TSIN1:PHAS 360
TSIG2:TSIN2:PHAS -360
*RST value
0
[SOURce:]TSIGnal:RECT:AMPLitude 0 ... +1 FS
The command sets the digital amplitude of the rectangular wave. The abbreviation FS means full
scale.
Example: TSIG:RECT:AMPL 0.5
*RST value
0.8
[SOURce:]TSIGnal:RECT:CREate
The command generates a waveform which is output directly.
This command triggers an event and therefore has no *RST value and no query form.
Example: TSIG:RECT:CRE
*RST value
-
1401.3084.32
'sets the number of periods of sine wave 1 to 4 and
the number of periods of the second sinewave to 6.
Resolution Options
'sets the phase offset of the I channel to 360 degree and
the phase offset of the Q channel to -360 degree.
Resolution Options
'sets the amplitude to 0.5 FS.
Resolution Options
'a signal is generated and output directly.
Resolution Options
AFQ Commands - Signal Generation
6.11
SCPI
Device-specific
SCPI
Device-specific
SCPI
Device-specific
SCPI
Device-specific
E-3