Usb Connection (Usb And Usb In) - R&S AFQ100A Operating Manual

R&S AFQ100A Hardware Interfaces

USB Connection (USB and USB IN)

The instrument is equipped as standard with five USB (universal serial bus) connectors.
USB
Four of them are type A interfaces (host USB) which establish a connection to the controller. They can
be used for connecting peripherals such as mouse and keyboard or a memory stick for data
transmission. Two of the master USB 2.0 connectors are at the instrument front. A third one is fitted at
the rear panel along with an USB 1.1 connector, labeled as USB 2 and USB 1, respectively.
USB IN
The fifth connector is an USB 2.0 type B interface (device USB) and located at the rear of the
instrument, labeled as USB IN. It can be used for remote control. The device ID required in this case is
31 (HEX) for remote control. The vendor ID is AAD (HEX).
1401.3084.32 8.9 E-3