Clock Dialog - R&S AFQ100A Operating Manual

R&S AFQ100A
Current Range
Without Recalculation
- Marker
Fix Delay to Current
range - Marker

Clock Dialog

The Clock dialog is used to select and configure the clock source. The Clock dialog is accessed via the
Baseband block.
To enable a very precise simultaneous signal output of several connected R&S AFQs, a special
synchronization mode can be selected in the Reference Clock area (see also following section
Up Several Connected R&S AFQs for Precise Simultaneous Signal Output
Note:
The clock signal also triggers the output signal for digital output on PORT 2 (see section
Output, on page 4.61).
1401.3084.32
Displays the dynamic range within which the delay of the marker
signals can be set without restarting the marker and signal.
Remote-control command:
SOUR:TRIG:OUTP2:DEL:MAX?
SOUR:TRIG:OUTP2:DEL:MIN?
Selecting this check box restricts the marker delay setting range to the
dynamic range. In this range the delay can be set without restarting
the marker and the signal.
Remote-control command:
SOUR:TRIG:OUTP:DEL:FIX ON
4.31
Baseband Block
Setting
on page 4.36).
Digital
E-3