R&S AFQ100A Operating Manual page 35

R&S AFQ100A
Removing and Installing the Hard Disk
For security reasons the R&S AFQ is equipped with a removable hard disk. The hard disk is located at
the front of the instrument.
NOTICE Risk of instrument damage and data loss!
During operation the instrument is accessing the hard disk. Removing the hard disk
while operating will lead to data loss or even instrument damage.
Do not remove the hard disk during operation.
For removing process as follows:
1. Switch off instrument.
2. Unscrew 2 milled screws at the hard disk cover.
3. Take off the hard disk slide-module carefully.
Safe keeping:
It is recommended to keep the hard disk in antistatic package in order to prevent damage to the disk.
For installing process as follows:
Unscrew the slot and remove the cover.
1.
Reassemble the hard disk by carefully sliding it into the slot.
2.
Remount the cover and screw-tighten it.
3.
The instrument now can be connected and power supplied.
Note:
The hard disk is supplied with pre-installed software and adjustment data and therefore bound to the
specific R&S AFQ. It cannot be replaced or installed in several R&S instruments.
For replacing an inoperable hard disk refer to the sevice manual, chapter 3 Service and Repair, or
contact the R&S support center. The hard disk needs to be installed at an authorized R&S service
shop.
1401.3078.62 1.15
Putting into Operation
E-3