R&S AFQ100A Operating Manual page 175

R&S AFQ100A
The output pins can be mapped to the signal or to a marker in the section Output Pin Assignment.
Note:
The section Output Pin Assignment is displayed only if PORT2 is activated.
Output Pin
Assignment
1401.3084.32
(Port 2 only)
Assigns the output pins LSB and LSB+1 of I and Q to signal or marker.
The Output Pin Assignment dialog is visible only if PORT2 is selected.
Maps the output pin LSB (= I[0]) of the digital port 2 to
Output Pin Ass.
either the I signal or marker 4.
I[0] (LSB)
Remote-control command:
SOUR:OUTP:DIG:PASS:I0 SIGN
Maps the output pin LSB+1 (= I[1]) of the digital port 2
Output Pin Ass.
to either the I signal or marker 3.
I[1] (LSB+1)
Remote-control command:
SOUR:OUTP:DIG:PASS:I1 MARK
Maps the output pin LSB (= Q[0]) of the digital port 2
Output Pin Ass.
to either the Q signal or marker 2.
Q[0] (LSB)
Remote-control command:
SOUR:OUTP:DIG:PASS:Q0 MARK
Maps the output pin LSB+1 (= Q[1]) of the digital
Output Pin Ass.
port 2 to either the Q signal or marker 1.
Q[1] (LSB+1)
Remote-control command:
SOUR:OUTP:DIG:PASS:Q1 MARK
4.64
Output Block
E-3