Load control
This part contains the sections describing the functions for controlling and balancing network
load.
10.1
Rate control
This section describes commands for controlling and restricting the data transmission rate of
an interface.
10.1.1
The "show" commands
This section describes commands with which you display various settings.
10.1.1.1
show rate-limit output
Description
This command shows the packet rate for limiting the outgoing data stream of one or all
interfaces.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show rate-limit output[interface<interface-type><interface-id>]
The parameters have the following meaning:
Parameter
interface
interface-type
interface-id
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
or
cli#
Description
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
10
Range of values / note
-
Enter a valid interface.
775